Standard Specification for Alloy-Steel and Stainless Steel Bolting for High Temperature or High Pressure Service and Other Special Purpose Applications
ASTM A193 specification covers alloy and stainless steel bolting for pressure vessels, valves, flanges, and fittings for high temperature or high pressure service, or other special purpose applications. Several grades are covered, including ferritic steels and austenitic stainless steels designated B5, B6, B7, B8, B8M, etc.
Selection will depend upon design, service conditions, mechanical properties, and high temperature characteristics. This specification is expressed in both inch-pound units
and in SI units; however, unless the purchase order or contract specifies the applicable A193M specification designation (SI units), the inch-pound units shall apply
Bolting Grade B8MLN
| B8MLN
| |
AISI 316LN Stainless Steel, Carbide Solution Treated |
ASTM A193 Grade B8MLN Chemical Composition
| Austenitic Steels, Classes 1C and 1D |
| Element |
Grade B8S, B8SA |
ASTM A193 Grade B8MLN Mechanical Properties
The material as represented by the
tension specimens shall conform to the requirements at room temperature after heat
treatment. Alternatively, stainless strain hardened fasteners
(Class 2, 2B, and 2C) shall be tested full size after strain
hardening to determine tensile strength and yield strength and
shall conform to the requirements prescribed in Table 2 and 3. Should the results of full size tests conflict with results of
tension specimen tests, full size test results shall prevail.
| Grade |
Diameter |
Tensile Strength |
Yield Strength |
Elongation |
Reduction |
Hardness |
ASTM A193 Grade B8MLN Marking Requirements
| Class |
Grade |
Grade Symbol |
| Class 1
| B8MLN |
B8G or B8MLN |
Recommended Nuts & Washers
| Bolting Grade |
Nut Grade |
Washer Grade |